Rustic Floral Cuff Bracelet
One common struggle in every rustic wedding is deciding on the accessories and attire. If you go too country, you look like a hillbilly, and if you don't go country enough, you don't fit in. Try the Rustic Floral Cuff Bracelet. You can make this bracelet yourself with just a few materials, and for a lot less than buying a similar bracelet pre-made. DIY jewelry is some of the most fun of being a homemade bride, so you'll love this bracelet tutorial. Try adding more flowers all around the band if you're looking to really glam up your hoedown.
Time to CompleteUnder an hour
Materials List
- Laliberi Purple Jade Oval Stone Petals
- Laliberi Green Adventurine Small Stone Petals
- Laliberi Peach Stone Small Stone Petals
- Laliberi Smoked Topaz Bicones 4mm
- Laliberi Vintage Rose Bicones 4mm
- Laliberi Crystal AB Bicones 6mm
Instructions
-
Cut an 18" piece of wire and thread through all of your large petals. Twist the wire a couple of times and wrap it several times in between all of the petals going in a circle. This will tighten the flower. Twist and trim wire on the back.
-
Cut another 12" piece of wire and thread on two AB crystals. Leaving a 2" piece in the back, wrap wire around the flower and metal cuff making sure the crystals are in the flower center. Add two more crystals and wrap again. Add two more and wrap then add one to finish. Twist wire several times and wrap and tuck behind flower to hide.
-
Repeat steps 1 and 2 for the other flowers. Use three crystals for each flower center.
-
Note:
-
Wrap flowers tightly around cuff so they don't move around.